Rain Bird ESP-4 Installation, Programming, & User Manual page 11

INSTALLING THE CONTROLLER
Select Location
The plastic, weatherproof cabinet of the ESP controller is suitable for mounting outdoors or indoors. For best
results, mount the controller at eye level in a sheltered location.
Allow approximately 7 1/2" of clearance to the left side of the controller so the controller door can swing fully
open. In addition, mount the controller so that 117-Volt AC power is readily accessible.
The ESP controller has three "keyhole" slots on the back of the cabinet. Use these slots to mount the controller
to a flat wall or vertical stud. Always use lower mounting hold "D" to secure the bottom of the controller.
Mount Controller
ΠOpen the controller door and swing the face panel out on its hinges from right to left.
• Place the open controller on the mounting surface and mark through the upper slots of the keyholes. (Use
keyholes A and C for wall mounting. Use keyhole B for mounting on a stud.) Then mark the location of hole
D.
Ž Remove the cabinet. Drive appropriate fasteners into the wall or stud at the upper keyhole marks (A, B, C).
Leave slightly more than 1/4" between the head of the fastener and the wall surface. Do not drive a fastener
into location D at this time.
• Hang the controller on the upper keyhole slots. Make sure the shafts of the fasteners are in the upper, narrow
portion of the slots. Then drive a fastener through lower mounting hole D. The controller should now be se-
cure.
Technical Support: 1-800-RAIN BIRD 11