Honeywell WEB/CP-202-XPR Installation Instructions Manual page 8

WEB/CP-202-XPR AND WEB/CP-602-XPR CONTROLLERS
Removing and Replacing the Covers
The controller has two plastic covers, each is secured by two #1 phillips head screws:
• Right cover — Must be removed first, provides access to all wiring terminals (controller and I/O wiring).
• Left cover — Remove only to install a SIM card (if a model with GPRS modem), install an option card, or to replace the
controller's NiMH battery pack.
See Fig. 3 for locations of the screws that secure each of the two covers.
WARNING
Remove 24V power before removing power wiring shield, before making any wiring terminations, or before
removing the left cover!
RIGHT COVER REMOVAL
REMOVE AND RETAIN
TOP AND BOTTOM SCREWS (2)
24 V POWER WIRING SHIELD
(SEE WARNING ABOVE)
To remove the right cover:
1. Using a #1 Phillips screwdriver, remove the two screws in the right cover as shown in Fig. 3, left.
Carefully set the screws aside to reuse.
2. Slide the cover towards the right to disengage.
3. Lift the right cover away from the unit, and set aside. Replace by simply reversing this procedure.
To remove the left cover:
1. Remove the right cover as described above.
2. Using a #1 Phillips screwdriver, remove the two screws as shown in Fig. 3, right.
Carefully set the screws aside to reuse.
3. Lift the left cover away from the unit, and set aside. Replace by simply reversing this procedure.
95-7775—01
Fig. 3. Controller cover removal.
8
LEFT COVER REMOVAL
REMOVE AND
RETAIN
TOP AND
BOTTOM
SCREWS (2)
M28865