Table of Contents
Advertisement
Installation Guide
Wiring
Note: Refer to the Danfoss Link™ Mobile Phone Butler (Danfoss
Link™ MPB) manual for wiring connections to the Danfoss
Link™ MPB.
Adding the device
The process of adding the Danfoss Link™ SCM
to a system is performed on the Danfoss
Link™ CC .
Note that the Danfoss Link™ SCM
must be added as a Service
Device .
When adding, press and
release the install button,
and observe that the LED
gives a fast green flash .
If adding is successful the LED turns green (HOME) or red (AWAY)
permanently - depending on input stage .
For further information, see the Danfoss Link™ CC installation
guide .
Note: If adding the Danfoss Link™ SCM to the Danfoss Link™ CC is
unsuccessful, make sure the right Danfoss Link™ CC software
version is applied. Correct version: 2.5.57 or higher.
4
Danfoss Link™ SCM
VIFZT102
© Danfoss
PWR+
PWR-
NC
COM
1.
03/2013
2.
Advertisement
Table of Contents
