Snooze Function; Activating And Deactivating The Alarm; Temperature Trend Display - DigiTech XC-0366 User Manual

Snooze function:

- When the alarm comes on, press the 'SNZ/LIGHT' to activate the snooze
function. When the snooze function is on, the "Zz' symbol will appear on the
display.
- The alarm will be snoozed by 5 minutes before coming on again.
- The snooze function can be interrupted by pressing 'MODE/SET' or 'ALARM' to
deactivate, or repeated up to 7 times by pressing the 'SNZ/LIGHT' button.

Activating and deactivating the alarm:

To activate or deactivate the alarms, press the 'DOWN' button:
- Press once: Alarm 1 activates
- Press twice: Alarm 2 activates
- Press three times: Both alarms are activated
- Press four times: Both alarms are deactivated

Temperature Trend Display:

After you insert the batteries, the weather station will measure the current
temperature. The trend display will show a neutral temperature course
(horizontal arrow). The further course of the trend display is determined as
follows:
- If after an hour the temperature is more than 1°C higher than the first value
measured, then a positive course is displayed (arrow pointing upwards).
- If after an hour the temperature is more than 1°C lower than the first value
measured, then a negative course is displayed (arrow pointing downwards).
- If the temperature does not change within the hour, then a neutral value is
displayed (horizontal arrow).
Relative Humidity Trend Display:
After you insert the batteries, the weather station will measure the current
relative humidity. The trend display will show a neutral relative humidity
course (horizontal arrow). The further course of the trend display is
determined as follows:
- If after an hour the relative humidity is more than 5% higher than the first
value measured, then a positive course is displayed (arrow pointing upwards).
- If after an hour the relative humidity is less than 5% higher than the first
value measured, then a negative course is displayed (arrow pointing
downwards).
- If the relative humidity does not change within the hour, then a neutral value
is displayed (horizontal arrow).
Maximum/Minimum Temperature and Relative Humidity:
- To toggle indoor/outdoor maximum/minimum temperatures and humidity
data, press the 'MEMORY' button:
Once to show the maximum temperature and humidity levels.
Twice to show the minimum temperature and humidity levels.
Three times to return to the current temperature and humidity levels.
- To reset the maximum and minimum temperature and humidity, press and
hold down the 'MEMORY' button for 2 seconds. This will reset all minimum
and maximum data recorded to the current displayed values.