Wiring Diagram - Panasonic DV-08VRE2 Installation Instructions Manual

WIRING DIAGRAM

Fan body
Motor
INSTALLATION (BETWEEN JOISTS MOUNTING)
IMPORTANT
Remove the tape from damper and adaptor before
installation. As shown below:
Joist situation:
Spacing A is 12 inches
(305mm) to 24 inches
(609mm) on center joists
Please follow the installation steps as below:
1. Insert the suspension brackets into the fan body
from each side of the bracket cover. (Fig. 1)
If spacing A between center joists is 12 inches,
cut all suspension brackets along the two "C"
cuts with a hacksaw or other tools.
2-"C" cuts
2. Fix suspension brackets and
(ST4.2X6), but remember not to tighten the
screws up yet. (Except that the spacing is 12
inches between joists.) (Fig. 1)
3. Position the fan body between joists, and
hold it properly. Mark the long holes of all
the four suspension brackets on joists. (Fig. 2)
4. Fix four long screws (ST4.2X20) partially into
joists at the four marked locations. (Fig. 3)
White
LED lamp
Red
Capacitor
White
White
Black
(114 °C Fuse in Motor)
Thermally protected
Adaptor
Tape
Damper
Joists
Before
After
with screws
Junction box
White
Black
Black
White
White
Black
Black
Green Green
Unit: inches (mm)
(ST4.2X6)
Gloves
Joist
Suspension
bracket
Unit: inches (mm)
Neutral
Power Supply
Live
AC 120 V 60 Hz
Neutral
Power Supply
Live
AC 120 V 60 Hz
Earth ground
Adaptor
Screw
Long hole
UP
Fan
Joist
body
Ceiling
>1/8 (3.2)
4-Long screws
(ST4.2X20)
joists
Suspension
bracket
Suspension
bracket
Bracket cover
Fig. 1
Suspension
bracket
Fig. 2
Fig. 3
5