1. Manuals
  2. Brands
  3. Markes International Manuals
  4. Laboratory Equipment
  5. Easy-VOC
  6. User manual

Markes International Easy-VOC User Manual

Hide thumbs
1
2
3
4

Advertisement

Table of Contents

User Manual
Easy-VOC
™
Contents
1. Introduction ......................................................................................... 2
2. Operation ............................................................................................. 2
2.1
Leak-Checking ................................................................................. 2
2.2
Taking A Sample ............................................................................. 2
3. Maintenance ........................................................................................ 4
3.1
Pump Inlet ....................................................................................... 4
3.2
Pump Mechanism .......................................................................... 4
Markes International Ltd
T: +44 (0)1443 230935 F: +44 (0)1443 231531 E: enquiries@markes.com
www.markes.com
Version 3.0 – September 2016
QUI-1073

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Easy-VOC and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Related Manuals for Markes International Easy-VOC

Summary of Contents for Markes International Easy-VOC

  • Page 1 1. Introduction ..................2 2. Operation ..................... 2 Leak-checking ................. 2 Taking a sample ................2 3. Maintenance ..................4 Pump inlet ..................4 Pump mechanism ................4 Markes International Ltd T: +44 (0)1443 230935 F: +44 (0)1443 231531 E: enquiries@markes.com www.markes.com...
  • Page 2 The pump should be leak-tested before use to ensure the volume taken is accurate. Fit the sampling end of a TD tube with a leak-tight cap.  Place the tube snugly, non-sampling end first, into the rubber inlet of the Easy-VOC. The tube should seal against the rubber without tightening the pump inlet nut.
  • Page 3  For additional pump strokes, push the handle back fully without removing the tube from the pump, then repeat the last two steps. The number of strokes taken can be recorded by rotating the counter on the pump. Markes International Ltd T: +44 (0)1443 230935 F: +44 (0)1443 231531 E: enquiries@markes.com www.markes.com...
  • Page 4 Inspect the gasket ring in the inlet end fitting, and replace if it is damaged, before screwing the end fitting back on. Inlet end fitting Inlet check valve Gasket ring Markes International Ltd T: +44 (0)1443 230935 F: +44 (0)1443 231531 E: enquiries@markes.com www.markes.com...

Table of Contents