Connections; Communication Setting - Sony XCL-CG510 Technical Manual

Connections

Communication Setting

Use the serial port assigned to the image input board for the camera. Communication settings are shown in the table
below. Echo back is performed for input commands.
Echo back can be set OFF to accelerate command responses. Commands are not case sensitive.
Baud rate 921600/460800/230400/115200/57600/38400/19200/14400/9600
Data bit 8
Parity None
Stop bit 1
Flow control None
Default values are underlined. (same applies hereinafter)
Command
BAUDRATE 115200/57600/38400/19200/14400/9600
BAUDRATE-TMP 921600/460800/230400/115200/57600/38400/
19200/14400/9600
BAUDRATE-SAVE 921600/460800/230400/115200/57600/38400/
19200/14400/9600
When you increase the baud rate, save them using the BAUDRATE-SAVE command after changing the settings
temporarily using the BAUDRATE-TMP command and confirming the communication between PC is enabled.
Parameter
11
Settings are saved in the camera and will be enabled
after restart.
Settings will be implemented immediately, but not
saved in the camera.
Settings are saved in the camera and will be enabled
after restart.