11 Advanced Features - Labgear S201 User Manual

11a SAT MANAGER
Your Labgear satellite meter has been loaded with
information on 100 of the most popular broadcasting
satellites around the world but if you want to add or
amend one you can do this in the
Sat Manager option:
• Add Satellite
• Edit Satellite
• Delete Satellite
Add Satellite: the setting refer to Antenna Setup.
Edit Satellite: press pq key to page up /down;
then press t u key to select the satellite; press OK to edit satellite setting, refer to Antenna Setup.
Delete Satellite: refer to Edit Satellite then press OK to delete satellite.
11b SAT SETTING
For any of the satellites already loaded onto your
meter you can amend a wide range of settings by
entering Sat Setting
• Sat Name - press t u to select satellite.
• LNB Type - press t u to select LNB Type.
• Low Freq - press t u to select Low Frequency or
press OK, then use the pq key to input the value.
• High Freq - press t u to select Hi Frequency or
press OK, then use the pq to input the value.
• TP NUM (Transponder) - press t u to select TP number.
• Frequency - Frequency of the current transponder, input the value by using the pq keys.
• Symbrate - symbol rate of the current transponder, input the value by using the pq and
t u keys.
Use the q key to scroll down to see the rest of the Sat Setting menu options.
• Polarity - press t u to change to vertical or
horizontal polarization.
• 22K - press t u to switch the 22KHz tone; if you
select "Universal" the 22K setting is AUTO.
• DiSEqC Mode - press t u to set the
communication protocol DiSEqC1.0/1.1 or
Unicable.
• DiSEqC type & Input - If you select DiSEqC 1.0/1.1,
then press t u to set the port number. If you select
Unicable, then press t u to select the IF Channel,
and use pq to input Centre Frequency.
• LNB Power- press t u to switch LNB power ON/OFF.
When all of settings are correct, press RETURN, then press OK for save the edit.
S201 - Advanced Features
7