Main Menu - Labgear S201 User Manual

5 Battery Charging
1. Ensure that the meter is switched off. Connect the charger plug to the charging socket (5)
on the right hand side of the meter.
2. Plug the charger into a mains socket the charging LED indicator (12) will light up green.
3. When the battery is fully charged, the charging LED indicator (12) will go out.
4. Unplug the charger from the mains socket and disconnect the charger from the meter.
Do not leave the torch unsupervised when charging is taking place.

6 Main Menu

Switch the power ON and you will enter the
main Menu which shows battery status and has
the following options:
• Sat Setting
• Signal Scan
• TOOLS
• SAT Manager
• TP Manager
• System Setup
7 Before You Start – choose the satellite and enter your location
Use the t u keys to select TOOLS and press (OK).
The display will open with the cursor on Satellite Name. To select a different satellite press u now
scroll up or down using the pq keys until you find the satellite you want. Satellites are listed in
order of their location angle, e.g.
No E/W
33
43
Select your satellite by pressing (OK).
Now scroll down and set your location. This is the location of the dish you are installing in
Longitude and Latitude. There are a number of places you can go to find your coordinates
including websites like
decimal place, which is roughly an accuracy of +/-3miles, which for initial dish alignment is more
than accurate enough.
Information is normally given like this:
Labgear factory
Post Code MK42 0NX
Longitude:
Latitude:
Use pq then (OK) to enter longitude then pq for each digit and t u to select East or West.
Repeat the steps for latitude using t uto select North or South.
4
S201 - Charging and Main Menu
Angle Name
E 13.0 Ku-HotBird 13
E 28.2 Ku-Astra 28.2
www.gridreferencefinder.com
-0.5 NOTE: a minus sign means WEST of Greenwich
52.1 NOTE: a positive is NORTH of the equator
. Your meter will accept entries to one