Connecting A Pf; Ethernet Connection; Serial Connection - Atlas Copco Power Focus 4000 User Manual

Getting started with ToolsTalk PF
6.4

Connecting a PF

There are different types of connection possibilities; Ethernet TCP/IP, Serial RS232 and USB. USB
connection is only available for PF 4000.
6.4.1

Ethernet connection

To make an Ethernet connection between PF and Tools Talk, PF must be configured with a unique IP
address. This address must be stored in Tools Talk.
Setting IP address in PF
Do either of the following:
 Connect a PC to PF through serial connection. Follow the instructions in section Network or set the IP-
address in PF from ToolsTalk.
 Use the keypad directly on PF. For PF Compact, select
 For PF Graph, press
Storing PF IP address in Tools Talk
 From the
menu, open the
Options
 Click the
Communication
to. Also click the option for
 Click the PF List tab, and create a list of PF. Note: To configure a cell or net, see section Network
 Save the settings and proceed to section To connect.
6.4.2

Serial connection

When using the serial connection, it is important to use the proper baud rate settings. In
order to establish a connection between ToolsTalk PF and PF they must use the same baud
rate. The default baud rate is set to 9600 bit/s.
From the menu, open the
Options
Make sure that the serial cable is connected to the correct
PF.
Open
PF Map>Controller>COM ports
Save the settings and proceed to section To connect.
68 (428)
and open the
PROG Controller>Network>Ethernet
Settings
tab,
Ethernet setup
NetMaster, CellMaster
dialog box. Check the Baud rate for the PC Com port.
Settings
and check the settings for PF, Serial 2
and enter the IP address.
F8
dialog box. Do either of the following:
area, type the Controller IP address of the PF to connect
or .
Controller
Com port
branch. Enter the IP-address.
on the PC and to Serial
C410 Baud rate
on
RS 232 (2)
.
9836 3123 01