DragonWave Horizon COMPACT Plus Product Manual page 105

Required Action
Configure the "wait to restore"
time (wtr)
Configure the EOAM option
Set the system to support the
diagnose haam [up/down]
command
Horizon Compact Plus Release 1.0.1
Steps
This command allows you to enter a time, in seconds, that the system
will wait before upshifting the modulation scheme after the link
improves. It is only applied when the system has downshifted to the
lower available modulation scheme.
Sequence:
set haam wtr [seconds] press Enter
Example:
set haam wtr 60 press Enter (sets a wait to restore time of 60
seconds)
The system responds:
HAAM wait-to-restore value is is set to 60.
get haam wtr press Enter
The system responds:
HAAM wait-to-restore value is 60.
This command enables (on) or disables (off) the HAAM EOAM option.
Sequence:
get haam eoam option press Enter
The system responds:
Eoam option for HAAM is: off.
set haam eoam option on press Enter
The system responds:
Eoam option for HAAM is set to : on.
Use this command to put the system into manual switching mode (on)
or automatic switching mode (off). Note that manual mode needs to be
enabled at both ends of the link for manual switching to work. This
command works together with the diagnose haam [up/down]
command.
Sequence:
set haam manual mode [on/off]
Example:
set haam manual mode on and press Enter
The system responds:
Modem1 manual mode set :Success
Warning:Please make sure that the peer system has the same
configuration!
Adaptive Modulation
Wireless Ethernet Product User Manual – Volume 2
97