Table of Contents
Advertisement
8.3.6 Set the CMS Server IP address and Server Port.
8.3.7 Set the Output pulse time and Ethernet parameter.
Output Pulse Time
0~9999S
Ethernet Parameter
Default "0",means getting IP and DNS automatically
a.1) With GPRS module, if not connect the Ethernet, device will send SMS: "
Ethernet connection failed, please check the wired network!"
2) With GPRS module, if the Ethernet connect the server failed or server not response, will SMS"
GPRS
ETH Connect Failure
Module
(optional)
At this time, the alert will transfer the data via GPRS; But if Ethernet connect successfully and
server response well, then not transfer the data via GPRS.
b. Without GPRS module, only transfer data via Ethernet.
Page 9 of 14
Notice:
The alert messages will be transmitted
to Server 2 (backup) once Server 1
failed after both of them are set.
"
Ver 1.2
Date: 20170805
Advertisement
Table of Contents
