Local Console - Tripp Lite B022-U16-IP Quick Start Manual

5. Installation
( continued )

5.5.1 Local Console

(continued)
2. Press the [F4] key to bring up the OSD Admin page.
3. In the OSD Admin page, highlight SET IP ADDRESS and press the [Enter] key.
4. DHCP – The first field allows you to enable or disable DHCP . When enabled, the KVM is assigned an IP address by the DHCP server. This setting is enabled
by default. To disable the DHCP setting and set up a fixed IP address, press the [Spacebar] key. Once the DHCP is disabled, you will be allowed to edit
the remaining fields in the SET IP ADDRESS screen.
5. In the remaining fields, enter in the IP address, subnet mask and default gateway you want to assign to the KVM switch.
6. Press the [Esc] key to exit the SET IP ADDRESS screen, and to pull up a prompt asking if you wish to save the settings you just entered. If you do not wish
to save the settings, press the [N] key. If you do wish to save the settings, press the [Y] key. Upon pressing the [Y] key, the settings will be saved and the
KVM will be reset.
5.5.2 IP Installer
The CD that comes with the product includes a Windows-based IP Installer utility that can be used to obtain and edit the IP address assigned to the KVM. To
use the IP Installer utility, the computer you are using must be running a Windows operating system, and must be on the same network as the KVM. Also,
the IP Installer setting in the Network page of the Web Management Interface must be set to Enabled, which it is by default.
Note: The IP Installer settings can only be accessed via the browser-based Web Management Interface. They are not accessible in the Remote OSD.
1. Save the IP Installer.exe file from the CD to a desired location on a
computer that is on the same network as the KVM.
2. Locate the IP Installer.exe file that you just saved and double-click on it.
A screen similar to the one below will appear:
5.5.3 Browser/Non-Browser Clients
By default, the KVM switch is set to have an IP address assigned automatically via DHCP server. If this is the case, you will need to obtain the IP address from
your network administrator. If connected to a network without a DHCP server, it boots with a default IP address. The default IPv4 and IPv6 addresses can be
found on the sticker on the bottom of the unit.
1. Enter the unit's IP address into your web browser.
2. You may be prompted by a screen stating that there is a problem with
this website's security certificate. Click on the option to continue to the
website anyway. (See Web Browser Login section for details on installing
the security certificate)
3. You will be brought to a login page. Enter the default User Name
(administrator), and the default Password (password). The Web
Management Interface will open upon entering the User Name and
Password. It is strongly recommended that you change these to a
unique username and password (see 5.5.4 Changing the Super
Administrator Login for instructions).
3. Select your KVM from the Device List.
Note: If the list is empty, or your device doesn't appear, click the Enumerate
button to refresh the Device List. If there is more than one device in the list, use
the MAC address on the bottom of your unit to determine the desired device.
4. To assign a fixed IP address, check the Use the following IP address
checkbox and fill in the IP Address, Subnet Mask, and Default Gateway
fields with information appropriate for your network (IPv4 or IPv6).
5. Click the Set IP button to apply the changes to the unit. The new IP
address will appear in the Device List.
6. Click the Exit button to exit the IP Installer utility.
4. Click on the Device Management icon at the top of the page, then click
"Network" in the sub-section to open the Network settings page.
7