Aligning Table - Grizzly G0555XH Owner's Manual

To set positive stop bolt so the is 90˚ to blade:
1. DISCONNECT MACHINE FROM POWER!
2. Make sure blade is properly tensioned
(refer to Tensioning Blade on Page 26 for
instructions).
3.
Loosen the two table lock knobs that secure
the table to the trunnions.
4. Loosen jam nut (see Figure 40) that locks the
positive stop bolt in place.
5.
Completely raise upper blade guide assem-
bly, then place machinist's square flat on
table and against side of blade, as shown in
Figure 40.
Positive
Stop Bolt
Jam Nut
Figure 40. Using a square to adjust the table
perpendicular to the side of the blade.
6.
Raise or lower the positive stop bolt until
table is perpendicular to side of blade, then
re-tighten jam nut (see Figure 40) against the
frame to secure setting.
7.
Rest table on positive stop bolt, then re-tight-
en table lock knobs.
8. Observe position of table tilt pointer on
tilt scale located underneath front of table
(see Figure 41).
-30-
Square
Table
9.
Observe position of table tilt pointer on
tilt scale located underneath front of table
(see Figure 41).
Tilt Scale
Pointer
Figure 41. Location of the table tilt scale.
10. Loosen Phillips head screw securing pointer,
adjust pointer to 0°, then retighten Phillips
head screw.

Aligning Table

To ensure cutting accuracy, table must be aligned
so miter slot is parallel with bandsaw blade.
Items Needed
Straightedge 24" ................................................ 1
Fine Ruler 12" ................................................... 1
Masking Tape .................................... As Needed
Open-Ended Wrench 10mm .............................. 1
To align table miter slot parallel to blade:
1. DISCONNECT MACHINE FROM POWER!
2.
Make sure blade is correctly tensioned (refer to
Tensioning Blade on page 26Pon page 26 for
instructions).
3.
Make sure table is perpendicular to side of
blade and is locked in place.
Model G0555XH (Mfd. Since 1/18)
Qty