Grizzly G0555XH Owner's Manual page 23

9.
Thread (2) M10-1.5 knobs onto trunnion bolts
hanging through bottom of trunnion base, as
illustrated in Figure 18.
Trunnion Base
Figure 18. Table installed on trunnions.
10. Install table insert (see Figure 19).
11. Attach table gap screw assembly with (1)
M8-1.25 hex nut and (1) 8mm flat washer
(see Figure 19), then tighten gap screw.
Note: Check this screw often to ensure table
surface is flush across gap.
Table Insert
Figure 19. Table insert and gap screw installed.
12. Install fence support using (2) M6-1 x 12
cap screws and (2) 6mm flat washers
(see Figure 20).
x 2
Figure 20. Fence support installed.
Model G0555XH (Mfd. Since 1/18)
Table
Trunnion
Knob
Gap Screw
Assembly
Fence Support
13. Attach fence rail using (2) M6-1 x 20 hex
bolts, (2) 6mm lock washers, and (2) 6mm flat
washers (see Figure 21).
Figure 21. Fence rail attached to table.
14. Thread M8-1.25 hex nut halfway onto M8-1.25
x 100 hex bolt (this is the positive stop bolt).
15. Thread positive stop bolt into threaded hole
on bandsaw body as shown in Figure 22.
Figure 22. Installed positive stop bolt.
x 2
Fence Rail
Positive Stop
-21-