GENERAL SAFETY RULES Use safety equipment. Always wear eye protection. Safety equipment such as dust mask, non-skid safety shoes, hard hat, or hearing protection used for ap- WARNING propriate conditions will reduce personal injuries. Read all instructions. Failure to follow all instructions Avoid accidental starting.
This will ensure that the safety of the power tool is maintained. SPECIFICATIONS SPECIAL RULES Wear ear protectors with impact drills. Exposure to Model CHI1442P noise can cause hearing loss. Voltage 14.4 V Chuck (mm) 2-13 CHARGER SAFETY Switch...
SPECIFICATIONS OPERATION Model CHI1802P CHARGING YOUR BATTERY PACK Voltage 18 V The battery pack for your tool has been shipped in a low charge condition to prevent possible problems. Therefore, Chuck (mm) 2-13 you should charge it prior to use. Switch Variable speed No load speed (drill mode):...
If the green LED continues to remain under normal circumstances, return both the battery pack on, return battery pack to your nearest Ryobi Authorised and charger to your nearest Ryobi Authorised Service Service Centre for checking or replacing.
OPERATION ELECTRIC BRAKE This drill has an electric brake. When the trigger switch is released, the chuck stops turning. When the brake is ADJUSTING THE TORQUE functioning properly, sparks will be visible through the vent See Figure 3. slots on the housing. This is normal and is the action of The tool is equipped with an adjustable torque clutch for the brake.
MAINTENANCE ENVIRONMENTAL PROTECTION WARNING Recycle raw materials instead of disposing as waste. The machine, accessories and packag- Do not at any time let brake fl uids, gasoline, petro- ing should be sorted for en-vironmental-friendly leum-based products, penetrating oils, etc. come in recycling.