Related Manuals for Black Box LPH1006A-R2
Summary of Contents for Black Box LPH1006A-R2
- Page 1 STEP X - Name of Step QUICK START GUIDE LPH1006A-R2 GB POE+ SWITCH 24/7 TECHNICAL SUPPORT AT 877.877.2269 OR VISIT BLACKBOX.COM...
- Page 2 STEP 1 - Overview LPH1006A-R2 Power Fault LED PW1 PW2 Fault Power LEDs DIP switch select 1000M 100M SFP Link/Act LED 100/1000BASE-X SFP port 100/1000X Green Link/Act Gigabit LAN Port Green PoE power injected 10/100/1000T...
- Page 3 STEP 1 (CONTINUED) - Overview TABLE 1. COMPONENTS ON THE SWITCH COMPONENT DESCRIPTION (2) Power LEDs (green) Lights when PWR1 or PWR2 to the switch is on DIP Switch Select Choose 1000 M or 100 M for Port 5 or 6 (2) SFP Link/Act.
-
Page 4: Step 2 - Install The Sfps
STEP 2 - Install the SFPs INSTALL THE SFPS Install two of the SFPs listed in the table below into the empty SFP cages on the switch. TABLE 2. COMPATIBLE SFPS SFP PART NUMBER DESCRIPTION LFP401 SFP, 155-Mbps Fiber with Extended Diagnostics, 850-nm MM, LC, 2 km LFP402 SFP, 155-Mbps Fiber with Extended Diagnostics, 1310-nm MM, LC, 2 km LFP403... -
Page 5: Step 3 - Set The Dip Switches
STEP 3 - Set the DIP switches DIP SWITCHES Locate the DIP switches on the top of the Industrial Ethernet PoE+ Switch and set them according to Table 3 below. TABLE 3. DIP SWITCH SETTINGS DIP 1 DIP 2 DESCRIPTION Power failure relay alarm disabled PWR 1 failure relay alarm enabled PWR 2 failure relay alarm enabled... - Page 6 STEP 4 - Install the switch on a DIN rail or wall Wallmount DIN rail installation installation...
-
Page 7: Connect Power
STEP 5 - Connect power and network devices CONNECT NETWORK DEVICES CONNECT POWER 1. Connect your devices using standard UTP/STP Connect the power to the switch as shown in the diagram below. cable, single-mode fiber cable, or multimode fiber cable with RJ-45 or LC connectors to the switch. - Page 8 STEP X - Name of Step COPYRIGHT 2017 BLACK BOX CORPORATION. ALL RIGHTS RESERVED.