Origin live Calypso MK3 Manual page 9

REPACKING METHOD - Please read carefully and pack exactly as
instructions show.
Wrap motor pod in polythene bag then tape ( or
rubber band) round the cardboard tube which has
a slit in it's side - the tube sits on top of the base
plate, not round it. This is to provide protection
against anything that might knock the end of the
motor shaft as this can cause damage. Note that
the motor pod must be positioned in this corner
of the box where there is the greatest depth i.e
not over the plinth armboard
Place the strobe card and belt in the top of the
motor pod card tube.
WRAP PLINTH IN POLYTHENE BAG BEFORE
LOWERING INTO BOX
VERY IMPORTANT -
This card and foam peice
must be placed here as
shown to protect platter
and ensure no damage to
sub-chasses
Place the wall wart transformer here and then place
the bubble bag containing the following items on top
of the transformer
Bag contains - Cork washer for arm, Oil bottle,
screw driver, 3mm & 2.5mm allen key
BELT & STROBE CARD PLACED IN MOTOR
POD PACKING
The belt needs to be rolled into a spiral and
placed in a small polythene bag - if loose packed
the belt can get crushed on bends and
permanently deformed.
Wrap platter and platter
mat in polythene bag
before placing in foam
cut out
Instruction manual