5. Operating Instructions
Control board function
Button
MENU
ENTER
UP
DOWN
Menu Instructions
[DMX address setting]
•
Press MENU when it shows [Address]
then press ENTER
•
Change the DMX address by UP or DOWN
[Function selection]
•
Press MENU until it shows [Intro] press ENTER
Press UP or DOWN to choose [Reset] , [Run].
•
When choosing [Reset] press ENTER and press UP or DOWN to choose [YES] or [NO]. When choo-
•
sing [YES],press ENTER into the whole light reset.
When choosing Run, press ENTER. Press UP or DOWN to choose [DMX512], [Auto1], [Auto2],
•
[Sound1] [Sound2], [Slave] When choosing [DMX512] the DMX controller sending the signal (3 pin
signal is valid),the corresponding display board DMX 512LED flashing.
When choosing [Auto1], [Auto2], [Sound1 ] or [Sound2], [Auto1], [Auto2], [Sound1], [Sound2],
•
choose Auto or Sound mode, it can be used as the master.
•
When choosing [Slave] it is Slave receive the Master signal.Choose the Slave need to quit to the main
menu can be controlled.
Function
Choose Menu or function exit
Current show menu or enter into the current selected
function
Increase the value
Decrease the value
Menu Map
7