Advertisement
Quick Links
ZN-7100-DE500-G V4
802.11ac Wireless Access Point
Quick Setup Guide
This Quick Setup Guide provides step-by-
step instructions on how to set up your ZN-
7100-DE500-G V4 Wireless Access Point.
After completing the steps described in
this guide, you will be able to place the AP
at your site and provide wireless network
access to users.
PACKAGE CONTENTS
• ZN-7100-DE500-G V4 Wireless
Access Point (1)
• Mounting screws and bracket (1)
HARDWARE OVERVIEW
Front View
LED Indicators on the Device
No
LED
State
Off
1
PWR
Green
On
Off
2
WLAN
Blinking
Green
Off
Green
3
LAN
On
Blinking
Green
Bottom View
Description
No.
1
No power to AP
AP power on, device
Rear View
ready
2.4G radio disabled
2.4G radio enabled
or data being
forwarded
Ethernet port not
connected
No.
Ethernet port
connected
1
Ethernet link activity
2
3
4
5
Item
Mounting Bracket Hooks
1
2
3 4
5
Item
Ground
LED
PoE/LAN Port
Reset Button
LAN Port (Option)
Advertisement
Related Manuals for Z-Com ZN-7100-DE500-G V4
Summary of Contents for Z-Com ZN-7100-DE500-G V4
-
Page 1: Quick Setup Guide
Mounting Bracket Hooks No power to AP PACKAGE CONTENTS Green AP power on, device Rear View ready • ZN-7100-DE500-G V4 Wireless 2.4G radio disabled Access Point (1) • Mounting screws and bracket (1) 2.4G radio enabled WLAN Blinking or data being... -
Page 2: Setup Requirements
SETUP REQUIREMENTS 1. Insert one end of an Ethernet cable to the The procedure for completing the Access Before installing your ZN-7100-DE500-G V4 access DATA/IN port on the PoE injector as figured Point’s essential configuration depends on point, be sure that you have the following: above. - Page 3 The Access Point requires a unique IP address (fixed IP or DHCP IP) on a network that has connectivity to a controller. The DHCP server can be an existing network server or a ZDC controller configured as a DHCP server. 1.
-
Page 4: Step 5: Install The Ap
12. Click Logout to exit the Web interface. MOUNTING THE ACCESS POINT STEP 4: VERIFY THE CONNECTION 1. Secure the ZN-7100-DE500-G V4 Access 1. Connect the AP to your network. Point to the mounting base with the 2. Use any wireless-enabled computer or provided screws. -
Page 5: Step 7: Power And Connect
1. Insert the other end to the LAN1/PoE page. Observe the wireless signal quality port on the ZN-7100-DE500-G V4. 1. Slide the locking nut over the bare end of and speed. the Ethernet cable. -
Page 6: Upgrading Firmware
4. Click Flash Image. Firmware update starts. Copyright © 2016 Z-Com, Inc. All rights reserved. ZDC is trademark of Z-Com, Inc. All other company and product names mentioned in the documentation are held to be trademarked (and registered) by the primary holders.