Advertisement
Quick Links
AC-1031 802.11ac
Wireless Access Point
Quick Setup Guide
This Quick Setup Guide provides step-by-
step instructions on how to set up your AC-
1031 Wireless Access Point.
completing the steps described in this
guide, you will be able to place the AP at
your site and provide wireless network
access to users.
PACKAGE CONTENTS
• AC-1031 Wireless Access Point (1)
• Mounting screws and bracket (1)
• PoE injector (1)
HARDWARE OVERVIEW
Front View
After
LED Indicators on the Device
No
LED
State
Off
1
PWR
Green
On
Off
Green
2
LAN 1
On
Blinking
Green
Off
Green
3
LAN 2
On
Blinking
Green
N
o
4
Bottom View
Description
No power to AP
AP power on, device
ready
Ethernet port not
connected
Ethernet port
connected
Ethernet link activity
Ethernet port not
No.
connected
1
Ethernet port
connected
Ethernet link activity
LED
State
Description
Wireless is
Off
disabled or no
link
WLAN
Wireless is
Green
enabled and link
On
established
Item
Mounting Bracket Hooks
Advertisement
Related Manuals for Z-Com AC-1031
Summary of Contents for Z-Com AC-1031
-
Page 1: Wireless Access Point
State Description No power to AP PACKAGE CONTENTS Green AP power on, device • AC-1031 Wireless Access Point (1) ready • Mounting screws and bracket (1) Ethernet port not • PoE injector (1) connected Green Ethernet port... -
Page 2: Setup Requirements
STEP 2: CONNECT THE AP TO YOUR 5. Click Login. SETUP REQUIREMENTS Before installing your AC-1031 access point, be sure that you have the following: STEP 4: CONFIGURE THE AP 1. Insert one end of an Ethernet cable to the... - Page 3 Configuring for Management by AP 2. On the main menu on the left, go to IP Address, Subnet Mask, Default Gateway, Controller Connection Info to check the Primary DNS Server, and Secondary DNS Server. To configure the Access Point to be managed connection status with the AP controller.
-
Page 4: Step 4: Verify The Connection
The AC-1031 can be mounted to a hard 2. Raise the selected ceiling tile on both 9. Adjust the maximum connected users if ceiling or suspended ceiling using the sides of the channel to remove the tile. -
Page 5: Step 6: Power And Connect
6. Insert a fastener into each mounting hole 1. Insert the other end to the LAN1/PoE port and tighten. on the AC-1031. 7. If necessary, drill or cut a cable access hole 2. Insert one end of an Ethernet cable to the in the ceiling tile large enough for the P+D/OUT port on the PoE injector. - Page 6 2. If you can connect, open a browser and link to any public website. Copyright © 2016 Z-Com, Inc. All rights reserved. ZDC is trademark of Z-Com, Inc. All other company and product names mentioned in the documentation are held to be trademarked (and registered) by the primary holders.