Table of Contents
Advertisement
Available languages
Available languages
EN
Settings
Device is switched off
Open confi guration mode: Keep
1 Select AutoHold: push
of time (5, 10, 15 or 20s) that a measuring value must be stable (deviation less
than 0.2°C) in order to be held, confi rm with
2 Select ALARM: push
value MAX. Keep the button pushed in order to accelerate the selection, confi rm
with
. If necessary, please repeat the process for the lower alarm value MIN,
HOLD
confi rm again with
, confi rm with
3 Select Temperature unit (°C or °F): push DOWN, push
unit °C or °F with
Device is switched on
1 Select AutoOff: Push
ment automatically switch-off after approx. 10 min when AutoOff is active.
2 Set Display illumination: push
light
.
Service and Maintenance
Change probe
Device must be switched off!
Turn threaded socket anti-clockwise and pull out probe. Mount new probe (please
take note of the contact pins) and fi x the threaded socket by turning it clockwise.
Clean the device
Do not use aggressive cleanser or solvent!
Clean the housing and the probe with a damp cloth (soap-suds).
1340-5130
04/10
pushed for >3 seconds.
HOLD
, push
HOLD
, push
, use
HOLD
, push
in order to switch the acoustic
HOLD
.
HOLD
, confi rm with
in order to activate or deactivate AutoOff. The instru-
, select
or use
.
HOLD
or
in order to set the upper alarm
.
HOLD
in order to activate or deactivate the display
Instruction manual
to adjust the period
signal
, select the requested
HOLD
or
11
Advertisement
Table of Contents
