Connect The Water - Haier HI50IB Installation And User Manual

INSTALLATION INSTRUCTIONS
REVERSING THE DOOR SWING
WARNING
to follow these instructions, leaving off parts, or overtightening screws,
can lead to the door falling off and result in injury and property damage.
To reverse the door:
1. Using a flathead screwdriver, remove the covers from the screw holes on
the side opposite the door hinges, top and bottom. Set aside.
2. Replace the hinge pin on Hinge 1 and tighten it firmly.
3. Remove the screws fastening Hinge 1 to the
cabinet and reinstall it on the opposite side of
the cabinet at the bottom.
4. Remove the screws fastening Hinge 2 to the
cabinet and reinstall it on the opposite side of
the cabinet at the top.
5. Using a flathead screwdriver, remove the hinge
pin from Hinge 2, and set it aside.
6. Rotate the door so that the handle is opposite
the hinge side and set the door onto the
bottom hinge pin.
7. Completely tighten the bottom hinge.
8. Insert the hole covers into the holes where the
screw were originally located.

CONNECT THE WATER

WARNING
The water supply should be ready at the point of installation. The water
supply pressure should be a minimum of 15 psig (103 KPa) with a static
pressure not more than 80 psig (552 KPa). (A wall outlet directly behind the
ice machine w3ill make installation easier.)
IMPORTANT:
• All installations must be in accordance with local plumbing code
requirements. Professional installation is recommended.
• Make certain the hoses are not pinched or kinked or damaged during
installation.
• Check for leaks after connection.
49-60811
Follow all steps when reversing the door swing. Failure
Connect to potable water supply only.
(Optional) (Cont.)
Hinge 2
Hinge 1
11