Installation Instructions; Unpacking; Reversing The Door Swing (Optional) - Haier HI50IB Installation And User Manual

INSTALLATION INSTRUCTIONS

UNPACKING

WARNING
Use two or more people to move and install ice machine.
Failure to do so can result in death or personal injury.
1. Remove packaging materials.
IMPORTANT: Do not remove any permanent instruction labels or the data
label on your ice machine.
2. Remove tape and glue from your ice machine before using.
• To remove any remaining tape or glue, rub the area briskly with your
thumb. Tape or glue residue can also be easily removed by rubbing a
small amount of liquid dish soap over the adhesive with your fingers.
Wipe with warm water and dry.
• Do not use sharp instruments, rubbing alcohol, flammable fluids, or
abrasive cleaners to remove tape or glue. These products can damage
the surface of your ice machine.
3. After you remove all of the packaging materials, clean the inside of your
ice machine before using it. See "Cleaning."
4. Properly dispose of/recycle all packing material.
REVERSING THE DOOR SWING
WARNING
to follow these instructions, leaving off parts, or overtightening screws,
can lead to the door falling off and result in injury and property damage.
Tools Needed:
• Flathead Screwdriver
To remove the door:
1. Unplug the ice machine or disconnect power.
2. Using a flathead screwdriver, remove the hinge pin from Hinge 1, and set
it aside.
3. Open the door about 20°, and then lift the door off Hinge 2, and set the
door aside.
Hinge 1
Door
10
Excessive Weight Hazard
Follow all steps when reversing the door swing. Failure
• Phillips Screwdriver
Hinge Pin
(Optional)
Cabinet
Hinge 2
49-60811