Specifications; Physical; Environmental; Optical Specifications - GarrettCom DynaStar DS2000-IFR Installation And Maintenance Manual

1 . 2 S
P E C I F I C A T I O N S
This section details the specifications covering the DS2000-IFR.
1 . 2 . 1 P h y s i c a l
Height:
•
Width:
•
Depth:
•
Weight:
•
1 . 2 . 2 E n v i r o n m e n t a l
Operating Temperature:
•
Storage Temperature:
•
Operating Humidity:
•
1 . 2 . 3 O p t i c a l S p e c i f i c a t i o n s
The DS2000-IFR has optional Small Formfactor Pluggable (SFP) fiber optic ports available in some
configurations. The specifications for these devices is included in the Table 1-1.
Port Type
100FX
Pluggable
SFP
100FX
Pluggable
SFP
100FX
Pluggable
SFP
GigE
Pluggable
SFP
GigE
Pluggable
SFP
"Typical maximum distance" is an estimated projection based on typical fiber installations; actual distance will depend on actual
network attenuation. For all MM (multimode) optics, the recommended fiber cable type is 62.5 / 125 µm fiber. Selected others
are supported, including 50 / 125 µm fiber for 100FX and 85/125 µm and 100/140 µm for 100 FX only. For 100FX SM (single
mode) optics, the recommended fiber cable type is 9 µm SM fiber.
DS2000-IFR Installation and Maintenance Guide
3.5 inches (8.9 cm)
17.5 inches (44.5 cm)
10 inches (25.4 cm)
11 lbs. (5 kg)
-20 to 60°C (-4 to 140°F)
-40 to 85°C (-40 to 185°F)
5 to 95% non-condensing
Table 1-1. Fiber Optic Specifications
DS2000-IFR Optical Interface Specifications (Optional SFPs)
Conn.
Mode
Type
LC MM
1310nM
LC SM
1310nM
LC SM
1310nM
LC SM
1310nM
LC SM
1310nM
Tx Power (dBm) Rx Sensitivity (dBm)
Min Max
-19 -14
-15 -8
-5 -0
-9 -3
-7 -3
1 - 3
C 1 -
HAPTER
Typical
Max Dist.
Min Max
-28 -8
-34 -10
-34 -10
-20 -3
-24 -3
Introduction

Specifications

2 km
15 km
40 km
10 km
20 km