Celina PINNACLE SERIES Product Manual page 8

8. Fasten the loop end of the 8' loop strap (B) to the carabiner. Secure the carabiner to the hook on the outside
of the corner fittings (the same hook that the tent top is secured to) and the side tee fittings.
9. Place stakes 5' out from each leg; drive stakes into the ground so that approximately 6" or less of the stake is
showing.
10. Attach the ratchet buckle with loop straps (A) to the stakes by turning the 6" loop at the end of the ratchet
inside out and pull the strap through the loop to create a noose and pull tight over the stake. Take the loop
strap (B) attached to the carabiner and pull it through the reel bars slot of the ratchet (ratchet buckle needs
to have handle facing upward at all times) and pull the loop strap (B) back towards the tent approximately 1 ½
feet. Hold the strap at this point with one hand and begin to crank the ratchet handle back and forth.
11. Once the top is in place and secured, you're ready to install the legs. Lift one side of the tent up and install
the legs (8') at the corners and side tee fitting, leaving the tent at an angle. Attach the base plate to each leg
with the smaller holes facing the interior of the tent.
12. Fasten the 6' series loop strap (D) to each corner and side tee through the two metal O rings on the tent
top, then through the end loop and tighten.
20' x 40' Pinnacle Series High Peak Frame Tent/Cross Cable Marquee
INSTALLATION INSTRUCTIONS
GetTent.com/CelinaTent.com/GetTent.co.uk © 2018 Celina Tent Inc. PG.8