Celina PINNACLE SERIES Product Manual page 10

16. Make sure the legs are straight then secure each base plate by driving a 24" anchoring hook into the
smaller hole of the base plate tighten all ratchet assemblies.
17. Roll excess ratchet straps and secure into the ratchet buckle.
Sidewall Setup Instructions: (This step in optional)
The sidewalls are designed to hang around the outside of the legs with the ratchet assembly on the exterior of
the sidewalls.
a. Hang each sidewall by buckling the straps on the top of the side wall around the spreader bar that
runs around the perimeter of the tent. Each sidewall will cover the distance between two legs. Loosen
the tent top tension if it is difficult to get the straps around the spreader bar.
b. Tighten the hanging straps so the sidewall is hanging at the appropriate height or fit with the ground
surface the tent is sitting on. Tuck the ends of each sidewall between the ratchet assembly and the tent
leg. Make sure the sidewall is centered between the two legs.
20' x 40' Pinnacle Series High Peak Frame Tent/Cross Cable Marquee
INSTALLATION INSTRUCTIONS
GetTent.com/CelinaTent.com/GetTent.co.uk © 2018 Celina Tent Inc. PG.10