Adam Eclipse Electric Fire Use And Care Manual page 7

INSTALLATION of the Eclipse Fire (into a stone or laminate back panel)
1) Stick one side of the Neoprene Strip
(x3) to the back of the electric fire (as
shown right). Position the fire within the
surround and peel back the other side of
the Neoprene Strips.
2) Check the supply cable is not trapped
under the fire such that it may cause it to
be damaged
3) Firmly push the electric fire against
the surround until it is secure.
4) Place the fret in front of the fire
5) Open the pebble set and place the pebbles
on the fuel bed randomly
CO9073
Use and Care Manual
Eclipse Electric Fire
Customer telephone helpline: 08448 809301
Helpline email address: helpline@adamsurrounds.co.uk
- 7 -
V3_210711