Adam Eclipse Electric Fire Use And Care Manual page 6

INSTALLATION of the Eclipse Fire (into a wooden back panel)
If installing into a stone or laminate back panel, please refer to page 7.
NOTE: Please take care when installing the fire as some edges may be sharp.
2) Unscrew the 8 screws to
detach the spacer
4) Offer the fire up to the spacer. Check the
supply cable is not trapped under the fire such
that it may cause it to be damaged.
5) Reattach the fire using the 8 screws,
then refit the TRIM using the opposite
procedure as illustrated in Actions 1 & 2.
6) Place the fret in front of the fire
7) Open the pebble set and place the pebbles
on the fuel bed randomly
CO9073
Use and Care Manual
Eclipse Electric Fire
1) Unclip the magnetised trim
Customer telephone helpline: 08448 809301
Helpline email address: helpline@adamsurrounds.co.uk
3) Attach the spacer to the
surround using 8 x (3.5 x 12mm)
screws or similar size
- 6 -
V3_210711