Table of Contents
Advertisement
important information on use
IMPORTANT NOTE
•
Handle the liquid crystal display (LCD) with care:
-
The LCD is a very delicate display device: Do not press its surface with excessive force, hit it or prick it with a sharp object.
-
If you push the LCD surface, unevenness in display may occur. If unevenness does not disappear, turn the camcorder off, wait
for a few moments, and then turn it on again.
-
Do not place the camcorder with the open LCD screen down.
-
Close the LCD monitor when not using the camcorder.
•
Liquid crystal display:
-
The LCD screen is a product of high precision technology. Out of the total pixels (approx. 230,000 pixels of an LCD monitor ),
0.01% or less pixels may be out (black dots) or may remain lit as coloured dots (red, blue, and green). This shows the limitations
of the current technology, and does not indicate a fault that will interfere with recording.
-
The LCD screen will be slightly dimmer than usual when the camcorder is at low temperature, as in cold areas, or right after
the power is turned on. Normal brightness will be restored when the temperature inside the camcorder rises. Note that the
above mentioned phenomena have no effect on the image in a storage media, so there is no cause for concern.
•
Hold the camcorder correctly:
-
Do not hold the camcorder by the LCD monitor when lifting it: the LCD monitor could detach and the camcorder may fall.
•
Do not subject the camcorder to impact:
-
This camcorder is a precision machine. Take great care that you do not strike it against a hard object or let it fall.
-
Do not use the camcorder on a tripod in a place where it is subject to severe vibrations or impact.
•
No sand or dust!
-
Fine sand or dust entering the camcorder or AC power adaptor could cause malfunctions or defects.
•
No water or oil!
-
Water or oil entering the camcorder or AC power adaptor could cause electric shock, malfunctions or defects.
•
Heat on surface of product:
-
The surface of the camcorder will be slightly warm when used, but this does not indicate a fault.
•
Be careful of unusual ambient temperature:
- Using the camcorder in a place where the temperature is over 104°F (40°C) or lower than 32°F (0°C) may result in abnormal
recording/playback.
- Do not leave the camcorder on a beach or in a closed vehicle where the temperature is very high for a long time:
This could cause malfunctions.
•
Do not point directly at the sun:
- If direct sunlight strikes the lens, the camcorder could malfunction or a fire could occur.
- Do not leave the camcorder with the LCD screen exposed to direct sunlight: This could cause malfunction.
•
Do not use the camcorder near TV or radio:
- This could cause noise to appear on the TV screen or in radio broadcasts.
vi_English
Hide quick links:
Advertisement
Table of Contents
