Table of Contents
Advertisement
Section 2:
Before you begin using the Quest Digital Recorder, you need to
initialize some of the settings on the Portable.
Load the Batteries
The Quest portable requires two AA alkaline batteries, two Nicad
Rechargeable batteries, or a DC 3V Power Supply.
To load the batteries:
1
Push and slide the battery compartment/door (9) downward.
2
Insert new batteries according to the label inside the battery
compartment. Lower and slide the cover back to its original position.
% Do NOT mix alkaline and rechargeable batteries; for best
performance, use only fresh batteries. If you already have installed
alkaline batteries, the DC 3V Power Supply will not damage them.
% If you do not intend to use the Quest portable for some time, remove
the batteries to avoid possible leakage.
Turn on the Portable
Slide the
Set the Time/Date
You should set the date and time settings when you first begin using the
Portable or whenever you change the batteries. When new batteries are
installed and the portable is first turned on, the date is set to
06-01-98.
Operate the Portable
Many procedures refer to using both a slide control and a button. You
can ignore the button reference if your Portable has a slide control.
To set the time:
With the Quest portable, two time formats are available. The 12-hour
setting, which identifies the time as
Specify the desired format on Screen 2.
2
Getting Started
On/Off
button (15) to the
On
position.
AM
or
PM
, and the 24-hour setting.
Advertisement
Table of Contents
