INDEX MACHINE DELIVERY pag. 3 INTRODUCTION TECHNICAL DESCRIPTION GENERAL INFORMATION MANUFACTURER RESPONSIBILITY INTERVENTION REQUEST TRANSPORT AND STOCKING PACKED MACHINE HANDLING UNPACKING THE MACHINE UNPACKED MACHINE HANDLING DESCRIPTION DASHBOARD SYMBOLS ON THE DASHBOARD USING THE MACHINE Braking System Hopper Discharge Main Brush Height Regulation Side Brush Height Regulation How to unblock the machine SAFETY, MAINTENANCE AND CONTROLS...
Page 4
TECHNICAL DATA LENGTH 2280 mm WIDTH 1470 mm HEIGHT 1500 mm BRUSHES No. SIDE BRUSH 600 mm Ø MAIN BRUSH (1.200mm length) 380 mm Ø WORKING WIDTH with right side brush 1500 mm WORKING WIDTH with right and left side brush 1800 mm WASTE TANK RECOVERY 450 lt.
Page 5
• %* (!" ) #%'()$ !#(% +(% #. ) . & '& '() !"# &) ( 8 • & !($ ) ..) • Fig. 1 Ing. O. Fiorentini MADE IN Piancaldoli (FI) ITALY Mod. S 48B S.N. 2009 Kg 1470...
CONTROLS DESCRIPTION DASHBOARD (22) (23) Shaker filter pilot light 15. interruttore luci di lavoro Suction fan pilot light 16. Windscreen wiper switch Engine air filter pilot light 17. - Gasoil pilot light 18. - Water temperature pilot light 19. Steering column with acustic signalling Pre-starting pilot light 20.
Water temperature Hopper open Flap closed Hopper closed Lights Battery charger Suction filters pilot light Main brush lift up Main brush lift down USE OF THE MACHINE Brake The machine is equipped with parking and service brake (picture no. 4). The service brake is hydraulic and is started by a pedal placed on the left of the footboard.
Page 10
Picture no. Hand brake lever Dust gaskets Screws for dust gaskets Use of the machine The sweeper is started by an hydraulic system based on a variable delivery pump started by a diesel engine and an orbital engine placed on the rear wheel (picture 5). In order to move the vehicle, the operator has to press the forward pedal.
Page 11
Picture no. 6 Regulate the height of the main brush • The operator ha sto regulate the aduste placed on the brushes jack Regulate the height of the side brushes • The operator has to regulate the knob under the brush arm...
Page 12
How to unblock the machine In order to tow the machine the operator has to unblock the hydraulic transmission (picture no. 7) and loose the by-pass cap. Picture no. 7...
Page 15
Picture no 8 Main brush 4. Hexagonal screws Side brush replacement The side brushes collect waste from the corners and carry it to the main brush. The rotation of the main brush is started by an hydraulic engine, while the its regulation is activated by a lever placed on the left side of the dashboard.
Check the efficiency of the safety devices every two years. The inspection has to be done by a trained technician. Every five years the machine ha sto be revised by a Fiorentini technician. Check on the electric system Every two years the electric system has to be checked. Burnt cables and not well fixed connections have to be checked and replaced.
Page 21
Mat. n. Serial no. _____________________ Nr. de serie Distributed by: ING. O. FIORENTINI S.p.A. “T ” HE BEST IN FLOOR MACHINES FILIALI: 20132 MILANO – Fax. 02/2592779 Via Palmanova 211/a – Tel. 02/27207783 - 2564810 00012 Guidonia Montecelio (ROMA) – Fax. (0774)353419 - 353314 Via B.
Need help?
Do you have a question about the S 48B and is the answer not in the manual?
Questions and answers