Inserting/Ejecting A Memory Card - Samsung SC-HMX20C User Manual

INSERTING/EJECTING A MEMORY CARD

Inserting a memory card
1. Open the memory card cover by sliding the OPEN switch upward as
shown in the figure.
2. Insert the memory card into the slot until it softly clicks.
• Make sure that the terminal portion is facing left and the camcorder is
placed as shown in the figure.
3. Close the memory card cover.
Ejecting a memory card
1. Open the memory card cover by sliding the OPEN switch upward as shown in the figure.
2. Slightly push the memory card inwards to pop it out.
3. Pull the memory card out of the slot and close the memory card cover.
The HD camcorder supports SDHC and MMCplus memory cards for data storage.
The data storage speed may differ, according to the manufacturer and production system.
• SLC (single level cell) system: faster write speed enabled.
• MLC (multi level cell) system: only lower write speed supported.
For best results, we recommend using a memory card that supports faster write speed.
Using a lower write speed memory card for recording a movie may cause difficulties with storing the movie on the
memory card. You may even lose your movie data during the recording.
In an attempt to preserve any bit of the recorded movie, the HD camcorder forcibly stores the movie on the
memory card and displays a warning: "Low Speed Card. Please record a Lower quality"
If you are unavoidably using a low speed memory card, resolution and quality of the recording may be lower than
the set value. page 63-64
However, the higher the resolution and quality, the more memory will be used.
Actual formatted capacity may be less as the internal firmware uses a portion of the memory.
English _27