Samsung SC-L810 Owner's Instruction Manual page 9

[ENGLISH 1
Notices and Safety Instructions
9. VENTILATION:
Slots and openings in the cabinet are provided for
ventilation to ensure reliable operation of
the CAMCORDER and to protect it from overheating.
These openings must not be biockod or covered,
Never place your CAMCORDER on a bed, sofa, rug, or
other similar surface: on or near a radiator or heat
register.
This CAMCORDER should not be placed in a built-in
installation such as a bookcase or rack unless
proper ventilation is providedor the manufacturer's
instructions have been adhered to.
10. POWER SOURCES:
The CAMCORDER should be operated only from the type
of power source indicatedon the label
If you are not sure of the type of power supply at your
home, consult your appliance dealer or local power
company.
A CAMCORDER is intended to be operated from battery
power,or other sources, refer to the operating instructions,
1 I.GROUNDING OR POLARIZATION:
This CAMCORDER may be equipped with either a
polarized2-wire AC line plug (a plughaving one blade
wider than the other) or a 3-wire grounding type plug,
a plug having a third (grounding) pin,
If you are unable to insert the plug fully into the outlet,
try reversing the plug.If the plug still fails to fit,
contact your electrician to replace your outlet.
Do not defeat the safety purpose of the polarized plug.
12.POWER-CORD PROTECTION:
Power-supplycords should be routed so that they are not
likely to be walked on or pinched by items placed upon or
against them, paying particularattention to cords or plugs,
convenient receptacles, and the point where they exit from
the unit.
13. OUTDOOR ANTENNA GROUNDING:
If an outside antenna or cable system is connected to the
CAMCORDER, be sure the antenna or cable system is
grounded to provide some protection against voltage
surges and built-up static charges, Section 810 of the
National Electrical Code, ANSI/NFPA No, 70-1984,
provides information with respect to proper grounding of
the mast and supporting structure, grounding of the
lead-in wire and supporting structure, grounding of the
mast and supporting structure, grounding of the leaddn
wire to an antenna discharge unit, size of grounding to
conductors, location of antenna-discharge unit, connection
to grounding electrodes and requirements for the
grounding electrode,
See figure below,
A