Fitting Your Electric Blanket - Sunbeam Sleep Perfect BL51 User Manual

Fitting your electric blanket

Note: The heat pad is designed to fit within
the edges of your mattress (see Figure 1).
This ensures the best, smoothest and firm
fit of your blanket to the mattress. As the
blanket settles in to the fit of the bed, any fold
ridges should smooth out over time.
Follow the instructions below for the type of
electric blanket you have purchased.
Fitted electric blankets
Place the electric blanket on your mattress
with the control sockets on the underside of
the blanket near the head of the bed (see
Figure 1). Ensure the heating wires do not
extend under the pillows.
Figure 1.
A single or king single Fitted or Antibacterial
electric blanket can be turned over so that
the control is on the preferred side of the bed
if desired. Please note that this may result in
the control facing towards the bed once the
bed is made.
6
Pull the elastic cord inside the fitted skirt
over the top corners of the mattress. To fit
the foot of the bed, pull from the centre of
the blanket to the foot of the bed, and fit one
corner at a time while holding the centre
(see Figure 2).
Ensure the fitted skirt and elastic cord go
completely under the mattress. Pull on the
edges of the blanket to ensure that it is flat
and square on the mattress.
Figure 2.