Getting Started; Site Requirements; Connecting Power - Philips Strand Lighting 100 plus series Operation Manuals

Operations Manual
LED Display
This will show alpha / numeric information about the console. Such as fade time, effect step rate, memory number
and whether the black out button is active.
LED Lights
All channel faders have LEDs that mimic the output level of each fader. LEDs also are indicators of the channel mode
as well as when all features are activated. All LEDs are green.
Black Out Button
This will allow the operator to instantly stop all fader output. Press again to restore fader output.

3. Getting Started

After unpacking the console and checking that you have all the included items shipped with your console (refer to
"Included Items" on page 3
lighting system.

Site Requirements

The 100 Plus Series Console requires a sturdy, flat surface for installation (unless the unit is to be rack mounted - see
"Rack Mounting" on page 7
should provide suitable ventilation. Also, the site should be clean (i.e. absent of any construction dust or debris) and
dry. Before setting up, ensure that the installation site meets these requirements. For operational and space
requirements, refer to

Connecting Power

The power supply shipped with your 100 Plus Series Console is an auto-ranging, universal voltage supply. It operates
between 90 to 240 VAC.
To connect the power supply:
Step 1. As shown in Figure 3, make sure unit's power switch is set to "Off"
Step 2. Connect DC connector from power supply to DC IN on console.
100 Plus Series Console Rear Panel
DC Input
Connector Pinout
Step 3. When DC connector is plugged in, twist it to lock in place.
Step 4. Connect power supply to AC supply source.
Step 5. Turn on console at Console On / Off Switch.
Note: You must connect the console to the lighting system via DMX512 before it is capable of providing control. See
"Connecting DMX512" on page 7
6
INTRODUCTION
for details), you may begin connecting your 100 Plus Series Console to power and
for information). The surface should be able to support the weight of the console and
"TECHNICAL SPECIFICATIONS" on page
PUSH PUSH PUSH
5 5 5 1 1 1
DM X
4 4 4 2 2 2
3 3 3
OUTPUT
1 - Ground
5 1
2 - Data -
4 2 3 - Data +
3
4, 5 - N C
9 to 12 Volts DC
0.5 Amps (min.)
Figure 3: 100 Plus Series Control Console Power Connection
for more information.
16.
POWER
9-12VDC,
ON / OFF
0.5A m in.
DC Input (from power supply)
Console On / Off Switch
RoHS
Made in P.R.C.