Memory Operation; Record Mode - Philips Strand Lighting 100 plus series Operation Manuals

8. Memory Operation

Memory mode allows you to program a cue stack of up to 99 memories. These can be played back sequentially. In
memory mode the buttons labeled in blue will be available.
2s 2.5s
3s
1.5s
30
1s 3.5s
0.5s 4s
5
0.2s 4.5s
10
0.1s 5s
5
2
Manual 5min.
FORWARD
RECORD
H OLD
DE L
To set the console to Memory Mode:
Step 1. Make sure the MODE Button is set to Memory mode. Change the mode by pressing the MODE button.
"Memory Mode" LED indicator will illuminate once the console is set to Memory Mode.
Step 2. The LED Display will show "00:00".
Step 3. The first two digits will be the currently outputting memory and
the second two digits will be the next available memory. In this
case (as shown to the right) there are no memories recorded.

Record Mode

To enter record mode hold down the MODE Button while in Memory
mode and then press the RECORD button. The Memory LED will blink to
show you are in Record mode.
The LED Display will show, "SS:00". The "SS" signifies an unrecorded
scene, "SP" signifies a recorded scene.
You can now set the 24 channel faders to the levels you require for the first
cue. When the cue is as desired, press the RECORD Button. This will
store the scene.
The display will automatically increment by one. If you wish to change the number use the [ + ] or [ - ] buttons. These
will increment or decrease the memory numbers.
When you have recorded your cues press the MEMORY button again. The
LED will stop blinking and the LED Display will show, "00:00".
3min.
4min.
REVERSE RANDOM
MODE
TWO SCENE
SINGLE SCENE
MEMO RY
Figure 12: Hold Button - Single Scene Mode
BLACKOUT
BOUNCE
PREVIEW
FLASH
OFF
CH 1-12
CH 13-24
100 Plus Series Console
LED Display
Memory Buttons
Mode Button
or
13
Memory Operation