Timer Tab - CamRanger MINI User Manual

Timer Tab

The Timer tab is accessed by pressing the stopwatch button and is used to configure the
CamRanger as an intervalometer and specify exposure times when the camera is bulb mode.
The initial delay is the amount of time to delay before the sequence is started. This can be
useful for making a custom timer mode with a set delay. The number of shots to take must be
entered as well as the time between shots. Note that depending on the camera, the time
between shots may be longer than entered if the time is less than a few seconds.
The estimated duration for the time lapse to complete is automatically calculated and
displayed, as well as the length of a 24 fps video if one was created from the resulting
captures.
If the camera is in manual mode, the HDR switch may be toggled on. Each capture will then
be an HDR sequence of captures. The HDR parameters are those that are set in the HDR tab.
Press "Start" to begin the sequence. After started, the iOS device does not need to remain
connected to the CamRanger. So there is no need to remain close by during a long time lapse
sequence.
© CamRanger
US Patent 9712688 09/07/18 12