INOKIM OX Super Manual page 19

REPLACING OSAP FROM LOW TO HIGH
In order to turn your OX into HIGH POSITION use the HIGH POSITION kit:
It is recommended that you place the OX on an uplifted surface such as a
chair or a box, so that the main body is firmly set on the surface and the two
wheels are in the air.
Remove the rubber caps and use the 19 mm socket spanner to release the
suspension arms from their location.
Once the suspension arm is out of its place, replace the OSAP from LOW
to HIGH in each suspension arm. Note to keep front and rear OSAP in their
places. Assemble back in a reverse order. You can use the sketch below for
assistance.
OSAP rear
Suspension arm
19mm washer
Bolt
Rubber cap
15