Replacing The Walking Belt - Cardiac Science ST 55 Service Manual

Repair/Replacement and Calibration

Replacing the Walking Belt

Remove the walking belt (see
1.
page 5-29).
Note: When you install a new belt, verify that the closed end of the splice on the
walking belt hits the roller first as the belt rotates.
Install a new belt, rough side up.
2.
There is a direction arrow on the inside of the belt.
•
To prevent scratches, use a piece of the old belt between the headframe and the
•
new belt.
Reassemble the treadmill following steps 1 and 2 in reverse order.
3.
Adjust the belt tension and tracking.
4.
Adjust the rear roller guards.
5.
70-00298-01 A
5-30
Removing the Deck Assembly from Headframe
Belt travel direction
Front roller
Open end of splice
on
Rear roller
TM 55/65 Treadmill 4.0