Introduction
Controls
Operation
The treadmill must be connected to the stress monitor. Except for the emergency stop
button, all commands, including walking belt power, speed, grade, and protocol, are
entered from the stress monitor. All patient data appears on the stress monitor screen.
Power
The treadmill must be plugged into a dedicated power outlet. The treadmill circuit
breaker, located on the front of the treadmill hood, must be set to ON and the stress
monitor power must be on for the treadmill to operate.
WARNING! Shock hazard.
Always turn off the circuit breaker on the treadmill before connecting to or disconnecting
from the power source.
1
2
3
Emergency Stop Button
The treadmill may have an emergency stop button located on the front handrail: the
button is optional on non-CE-marked units. When pressed, the button cuts power to both
the belt motor and the grade motor. The stop button is intended only for an emergency
situation.
70-00298-01 A
2-2
Emergency Stop Button Interface
1
2
Circuit Breaker
Power Cord
3
Stress Monitor Interface
4
4
TM 55/65 Treadmill 4.0