Table of Contents
Advertisement
Chapter V Menu Programming
All of the programming functions of V2040 can be accessed
through the Main Selection menu.
5.1 Main Selection Menu
To access the Main Selection Menu:
1. Make sure that the programming monitor has been connected to
the BNC connector labeled as "PROG MON" on the back panel
of V2040.
2. Place the key-switch in the MENU position.
5.2 Menu Navigation and Operation
Please refer to the following guidelines for menu navigation and operation:
Function
Position the cursor
Scroll multiple pages
Access a sub-menu
Return to the previous menu
Function
Select an entry value
Enter an entry value
Exit menu programming
5.3 System Menu
Access the SYSTEM menu from the MAIN SELECTION menu.
System Time and Date, Tours, Salvos, Alarm Contacts, Event
timers and Monitor Status are programmed in this menu.
MAIN SELECTION
1 SYSTEM
2 MONITOR
3 CAMERA
4 PORTS
5 ACCESS
6 PRIORITY
7 SATELLITE
28
Instruction
The blinking line on the menu screen indicates the current cursor location.
There are usually two ways to move the cursor:
Press one of the following keys for the designated direction:
NEAR (left), FAR (right), WIDE (up) and TELE (down); or
Push the joystick in the direction in which you want to move the cursor.
Some menus may include multiple pages.
To turn to another page, use the following keys:
CLOSE (page up) and OPEN (page down) in the IRIS section; OFF (page
backward) and ON (page forward) in the AUXILIARY section.
There are two ways to access a sub-menu:
Move the cursor to the desired sub-menu, and press the ACK key; or
Enter the number for the desired sub-menu, and press the ACK key.
Move the cursor to the bottom line, i.e., RETURN MAIN or PREVIOUS MENU, and
press the ACK key.
Instruction
1)
Press the ACK key to toggle through the available values. If the cursor moves to
the next entry, it indicates the value has been selected. Otherwise, continue with
Step 2.
2)
Press the NEXT key to accept the selected value and move to the next field.
1)
Enter the desired number (or code number) on the numeric keypad.
2)
Press the ACK key to confirm.
Place the key-switch in the OPERATE or PROGRAM position.
SYSTEM
1 SET TIME AND DATE
2 SET SYSTEM TOURS
3 SET SYSTEM SALVOS
4 SET EVENT TIMERS
5 SET ALARM CONTACTS
6 MONITOR STATUS
RETURN MAIN
The programming monitor will display the Main Selection Menu
shown below.
MAIN SELECTION
1 SYSTEM
2 MONITOR
3 CAMERA
4 PORTS
5 ACCESS
6 PRIORITY
7 SATELLITE
V2040 Main Selection Menu
The Main Selection menu is displayed as above, indicating the
menu programming functions are available.
5.3.1 Setting Time and Date
SYSTEM
1 SET TIME AND DATE
2 SET SYSTEM TOURS
3 SET SYSTEM SALVOS
4 SET EVENT TIMERS
5 SET ALARM CONTACTS
6 MONITOR STATUS
RETURN MAIN
Use the SET TIME AND DATE menu to set the date format, date,
time and day of the week for on-screen displays.
SET TIME AND DATE
DATE FORMAT - MM-DD-YY
A
DATE - 08-25-02
B
TIME - 15:20:30
C
DAY OF WEEK - FRI
D
PREVIOUS MENU
Advertisement
Table of Contents
