Hitachi Compute Blade 320 Instruction Manual page 80

3. The "BIOS Utility" terminates. Press [X] and then [Y].
Reboot the System to Make All the Change to Take Effect!
REBOOT THE SYSTEM (Y/N)
• • •
When you press [N], the screen returns to the state just after start of the BIOS Utility.
Tip
<< Using BIOS Utility version 2.12a13 or higher >>
1. Open the "BIOS Utility" screen. Select "Enable/Disable Boot from SAN" and press [Enter] key.
2. Select "Enable" or "Disable" and press [Enter] key.
If you want to perform SAN Boot from the registered device, set the item No. 1 of Adapter's
• • •
Tip
Parameters to "Enable".
7-8
Supplementary Notes on Fibre Channel Adapter Function