Hitachi Compute Blade 320 Instruction Manual page 42

14. Reboot the system.
The following warning message is logged in the Event Log with Fibre Channel Driver ,
!
but this is no problem.
Note
Warning messages：
Event ID :2858
Source : lpfc
Messages:"lpfc 0000:05:00.0: 0:(0):2858 FLOGI failure Status:x3/x18 TMO:x0 "
□
Installing OneCommand Manager
The installation procedure for the utility of the Compute Blade 2000 / Compute Blade 320 Fibre Channel adapter is described below:
1. Turn on the power of the system unit, start Red Hat Enterprise Linux, and log on with "root".
2. If OneCommand Manager is not installed yet, skip step 2~3 and go to step 4.
If it is already installed, display the information of OCM_CLI version. Execute the following command and see the value of
"Command Line Interface" column.
# hbacmd Version
3. Confirm that the version is listed in Table 2. If the installed utility is listed, the installation is not necessary.
If the installed driver is needed to be updated, go to step 4.
Table 2
<< CB320 >>
Fibre Channel Adapter FW version
<< CB2000 >>
Fibre Channel Adapter FW version
4. Insert "Driver and Utility" or "Server installation and monitoring tool" media into the DVD-ROM drive of system console.
Select [Tools] - [Launch Virtual Media] located in upper side of Remote Console menu and open [Virtual Media Session] window.
Check the "Mapped" check box of the CD/DVD drive to set the virtual drive.
5. Mount the "Driver and Utility" or "Server installation and monitoring tool" media to any directory in the system, the directory "media" is
made for example
# mount /dev/cdrom /media
5-20
Don't care
1.1**** or lower
2.01A12 or higher
Installing the Driver and Utility
OneCommand Manager Version
RHEL 6 (x86) RHEL 6 (x64)
6.1.34.2 6.1.34.2
OneCommand Manager Version
RHEL 6 (x86) RHEL 6 (x64)
6.1.34.2 6.1.34.2
6.3.16.2 6.3.16.2