Hitachi Compute Blade 320 Instruction Manual page 78

□
Factory default settings and confirmation of defaults
Parameters of the adapter and their values set at the factory are described below:
No. Setting
.
1 Enable or Disable BIOS
2 Change Default ALPA of
this adapter
3 Change PLOGI Retry Timer
( +Advanced Option+)
4 Topology Selection
( +Advanced Option+)
5 Enable or Disable Spinup
delay
( +Advanced Option+)
6 Auto Scan Setting
( +Advanced Option+)
7 Enable or Disable EDD 3.0
( +Advanced Option+)
8 Enable or Disable Start
Unit Command
( +Advanced Option+)
9 Enable or Disable
Environment Variable
( +Advanced Option+)
10 Enable or Disable
Auto Boot Sector
( +Advanced Option+)
11 Link Speed Selection
( +Advanced Option+)
7-6
Description
Set whether to enable or disable ROM BIOS.
Set the adapter's ALPA. (HEX)
Set the retry interval for PLOGI.
Set the Loop mode.
Set whether to enable or disable maximum
3-minute wait time for completion of hard
disk spinup in the disk array unit.
The setting in case where there is a bootable
OS. Not supported in this adapter.
Not supported in this adapter.
Not supported in this adapter.
Not supported in this adapter.
Set the boot sector (32 or 63) automatically.
Set the transfer speed.
Supplementary Notes on Fibre Channel Adapter Function
Selectable value Factory
default
1: Enable Disable
2: Disable
01 to EF
1: 0 msec 000
2: 50 msec
3: 100 msec
4: 200 msec
1: Auto Topology Auto
(Loop First) Topology
2: Auto Topology (Loop
(Pt to Pt First) First)
3: FC-AL
4: Fabric Point to
Point
1: Enable Disable
2: Disable
1: Autoscan disabled Autoscan
2: Any first device Disabled
3: First LUN 0 device
4: First NOT LUN 0
device
1: Enable Disable
2: Disable
1: Enable Disable
2: Disable
1: Enable Disable
2: Disable
1: Enable Disable
2: Disable
0: Auto Select Auto Select
1: 2 Giga baud
2: 4 Giga baud
3: 8 Giga baud
00