Placing The Indoor Unit In Position - Samsung AD18B1C09 Owner's Instructions & Installation Manual

C I
OMPLETING THE NSTALLATION

Placing the Indoor Unit in Position

Installation plate
46
E-
Once you have checked that there are no leaks in the system, you can insulate
the piping, hose and cables and place the indoor unit on the installation plate.
1 To avoid condensation problems, place heat-resistant polyethylene foam
separately around each refrigerant pipe in the lower part of the indoor unit.
2 Wrap the refrigerant pipes and the drain hose located at the rear of the
indoor unit up in the absorbent pad.
Triply wind the pipes and hose to the end of the indoor unit with
the absorbent pad (make intervals of 20mm /
3 Wind insulating tape around the pipes, assembly cable and drain hose.
4 Place the resulting bundle carefully in the lower part of the indoor unit,
making sure that it does not jut out from the rear of the indoor unit.
5 Hook the indoor unit on to the installation plate and move the unit to the
right and left until you are sure that it is securely in place.
6 Finish wrapping vinyl tape around the rest of the piping leading to the
outdoor unit.
7 Using clamps (optionally supplied), attach the piping to the wall wherever
possible.
3
inch).
4