Table of Contents
Advertisement
button. This will change the flashing ft/m term to mph, also
flashing. Press the SET button again and mph will turn to knots.
Press it again to change knots to m/s.
Press the SET button as many times as
necessary until the air/wind speed unit
you prefer appears, flashing, at the
right of the upper readout. To save this
unit, press the UNIT button. The figure
at right shows the five available
air/wind speed units in their selection
sequence.
When you press the UNIT button to
save your preferred air/wind speed unit, °F—the DAF3012M's
factory default temperature measurement unit—will begin
flashing in the lower right corner of the LCD. To keep °F as the
temperature measurement unit, begin by pressing the UNIT
button. This will cause °F to stop flashing and the meter to
resume displaying real-time air/wind speed and temperature
measurements. To change the temperature unit to °C, press the
SET button, followed by the UNIT button to save the selection.
The DAF3012M will "remember" the air/wind speed and
temperature units (as well as its operating mode and other
selected units and parameters) in use each time it powers off and
will resume operating in that mode and with those units upon
restart. So if you always use ft/m and °F for air/wind speed and
temperature measurements, you need not perform any of the
above steps. And if you always use the same air/wind speed and
temperature units (other than ft/m and °F), you need only perform
the above procedure once. Unlike many instruments, changing the
battery does ot reset all units to their factory default.
As mentioned earlier, the DAF3012M automatically begins
measuring and displaying ambient temperature upon startup. To
display other temperatures whose calculation includes the
8
Advertisement
Table of Contents
