Storing And Recalling Records - General DAF3012M User Manual

STORING AND RECALLING RECORDS

The DAF3012M can store up to 20 pairs of the measurements
shown on the upper and lower readouts for later recall in
chronological order (the order in which they were stored).
To store the pair of readings currently on-screen, press the
REC button. The readings will be stored at the location indicated
by the memory counter (Fig. 2, Callout M) above the memory
pointer JOB (Callout L). Note that each press of the REC button
increments the memory counter by 1. The DAF3012M's memory is
nonvolatile, so stored pairs of readings (collectively called a
Record) are retained when the meter powers off, and also after
the battery is changed.
To recall one or more readings, make sure the meter is
operating in one of the three real-time measurement modes
(air/wind speed, RH or barometric pressure), with no terms
flashing on screen. Then press the RCL/DEL button once. This
will replace the term JOB by the memory recall mode indicator
Rec (Fig. 2, Callout N) above. Both readouts will switch to
displaying the oldest record saved (the pair of readings in memory
location 01).
To display the next-newest record, press the SET button. Continue
pressing the SET button to sequentially display all stored records
in the order in which they were saved. Pressing the SET button
with the newest record on-screen resets the memory counter to
01. To exit memory recall mode, briefly press (but do not hold) the
RCL/DEL button. This will replace the term Rec above the storage
location number by the term JOB below it.
When the DAF3012M's 20-record memory is full, pressing the
REC button will not store the current pair of readings—in other
words, the memory is not over-writing. To store readings with a
full memory, you must delete one or more records manually.
11