Table of Contents
Advertisement
CONTENTS
&
BEFORE YOU START
Introduction
Congratulations on your purchase of a UDC
controller. Once you've studied these instructions and
used the controller a few times, the UDC
as easy to use as a digital wrist-watch. But be prepared
to spend some time learning to use it.
The typical digital wrist-watch
things once you know how to use it. But if you never read
the instructions for it, that same wrist-watch will annoy
you by beeping at odd hours. If you study this manual,
you will be delighted at the firing power at your disposal.
If you don't read it, you'll never really appreciate your
controller.
If you purchased the controller as part of a kiln or
furnace, you will find a furnace manual in this instruc
tion packet. Please read the furnace manual first, then
this manual.
While you're learning to use the controller, leave your
furnace's on/off switch in the OFF position. This will
allow you to experiment with the controller without
powering the elements. Mter you complete a firing, turn
the on/off switch to the OFF position.
Thank you for purchasing this controller. We trust
that it will open a new world of convenience for you.
2000
The UDC
controller is warranted for two years.
This warranty includes immediate technical assistance·
via a toll free telephone number and complete replace
ment of the controller if necessary. For technical assis
tance, dial
1-800-423-9883.
Your model and serial number is
OC2003-0-0080-0000-00-0111
Here's how to remove the controller from your kiln in
the event that you need to return it to the factory under
warranty:
1.
Loosen the screw on the face ofthe controller.
2.
Pull the controller out.
When reinstalling, make sure the controller slides
under the guide clip at the bottom of the controller. Push
the controller in all the way.
© 1990, by Paragon Industries
1
2
3
4
5
5
6
2000
2000
will be
will
do some amazing
IM111f9.90
An
electric kiln
furnace is safe to operate provided
or
you follow these basic safety rules:
Do not touch hot sides.
•
Keep unsupervised chiidren away.
•
Place kiln on stand before connecting power.
•
Do not install closer than 12" from any wall or
•
combustible surface.
Do not open lid or door until kiln has cooled
•
and is completely shut off. I f you must open
while hot, wear appropriate protective gear.
Fire only in well ventilated, covered and
•
protected area.
Dangerous voltage: Do not touch heating
•
elements with anything.
Disconnect kiln before servicing.
•
Do not leave unattended while firing.
•
•
Turn on/off switch to
is completed.
OFF
position when firing
6
6
6
9
9
9
10
10
10
10
Hide quick links:
Advertisement
Table of Contents
