Cleaning Instructions - Russell Hobbs RHG2T Classic Satin Owner's Manual

User Maintenance Instructions
3. Lift the Glass Panels off. Remove the Washers from the back of
the Glass— don't lose them!
4. Wash the Glass Panels in warm soapy water and dry
thoroughly.
5. Replace the Glass Panels, one at a time.
IMPORTANT: Avoid touching the insides of the Glass Panels to
prevent smudges or fingerprints on the Glass.
6. Fit the small end of the Washers into the holes behind the
Glass. Hold the Glass firmly so that the holes align with the
holes in the Toaster.
7. Replace the Screws and finger-tighten only — don't use tools.
WARNING: DO NOT USE PLIERS OR ANY OTHER TOOL TO REPLACE
SCREWS. USING ANY TYPE OF TOOL MAY DAMAGE THE FINISH
ON THE SCREWS AND BREAK THE GLASS.

CLEANING INSTRUCTIONS

CAUTION: Do not immerse Toaster, cord, or plug in water or any
other liquid.
CAUTION: Be sure the Toaster is unplugged before cleaning.
Wipe the Toaster exterior with a clean, damp cloth. Do not use
abrasive cleaners. Do not put cord, or plug in water or liquid.
CRUMB TRAY: Remove the Crumb Tray at bottom of the Toaster by
pulling the Crumb Tray away from the bottom of the Toaster,
allowing the crumbs to fall out.
We suggest that you do this over a sink or over a garbage can.
Wipe the Crumb Tray with a clean, damp cloth. Replace the
Crumb Tray, making sure to push firmly so that it is fully inserted in
the bottom of the Toaster.
EXTERIOR: Wipe surfaces with a clean, damp cloth. Do not use
abrasive cleansers, as they may scratch the surfaces.
STORAGE INSTRUCTIONS
Unplug unit, allow to cool, and clean before storing. Store Toaster
in its box in a clean, dry place. Never store Toaster while it is hot or
still plugged in. Never wrap cord tightly around the appliance,
use the Cord Storage area on the bottom of the Toaster. Do not
put any stress on the cord where it enters the unit, as it could
cause the cord to fray and break.
10
(Continued)